Ring test

[Siegfried]

This ring was modelled in Rhino and rendered in Flamingo. Just a small test.
Also, I add some fake DOF in PS, not a good move...

[choppy]

已經很正了!!!!
我覺得高光暗左o的.

[h2o]

好正, 不過鑽石點解唔 ren 真 model 呀, 用 mapping 差d

[badBoy]

cool! look forward to c more post from u~

[Siegfried]

已經很正了!!!!
我覺得高光暗左o的.

As I'd prefer low-profile rendering but thanks for your comment !!!

[Siegfried]

好正, 不過鑽石點解唔 ren 真 model 呀, 用 mapping 差d

yes ar...Flamingo is pretty weak at manual control of shadowing, lighting and raytracing (object exclude etc )....and this rendering takes just a couple minutes for calculation, so the quality is compromised...

[Siegfried]

cool! look forward to c more post from u~

OK, a promise is a promise ! Your comments are always welcomed.

[Siegfried]

Here are some Flamingo Toon Shading, it takes several seconds only for each rendering, in such a resolution.

[新 Ricky]

Siegfried //

It nice render pix !
My comment is the corner of floor, I also has this problem
always and painful to remove it !!

[Siegfried]

Siegfried //

It nice render pix !
My comment is the corner of floor, I also has this problem
always and painful to remove it !!

Far corner in the wireframe rendering...here's a solution...
Generate the model wireframe and composite with another infinite grid in PS.

[新 Ricky]

Siegfried //

It nice render pix !
My comment is the corner of floor, I also has this problem
always and painful to remove it !!

Far corner in the wireframe rendering...here's a solution...
Generate the model wireframe and composite with another infinite grid in PS.

yes, I try this method before......... but looks......
I dont know how to say....... I guess some rendering expert
should have another solution.......

below pix is mine, pls comment ar.......!!!

[Siegfried]

Here's my little thought of your rendering...

If you want the client to focus on the design, then a spot-light is recommended, but at the same time, adequate lighting to show all the detail of the product is necessary, except additional detail drawing is provided.

What's the surface finish of the frame ? Spray or electroplating?
And why don't you rendering one more but have the frame folded?

[新 Ricky]

Here's my little thought of your rendering...

If you want the client to focus on the design, then a spot-light is recommended, but at the same time, adequate lighting to show all the detail of the product is necessary, except additional detail drawing is provided.

What's the surface finish of the frame ? Spray or electroplating?
And why don't you rendering one more but have the frame folded?

Siegfried //
haha..........thanks again !
I understood lu....... since this rendering is practice only on
4-5 yrs ago...... and not a design project ( Okaley ) , just train
my skill in modeling and rendering .......
I think u must be very familiar in the finishing / color styling tuning !

Really want to follow u for learning !!!

[Siegfried]

No la, almost 90% of my product (in the company I'm serving) are being sprayed. But for spectacle, I doubt the spray would have an allergy to the skin when it comes to heavy sweating....

[新 Ricky]

icic......... now
u mainly for which market ? e/e , watch , eyewear, ......etc?