在 2002-01-20 03:28, landrover 寫了:
我都check 過個cfg file , 無set 錯...
所以我都唔知系咩問題
it's not the config file, it's may be the problem of lwsn cannot find the correct path of the config file.
for example, in my shortcut lwsn1.bat ( I use lightnet )
X:LightWave_3D_7.0ProgramsLWSN.EXE -2 -cX:LightWave_3D_7.0Configs x:LightnetJob1 x:LightnetAck1
the -c tell lightwave to look into X:LightWave_3D_7.0Configs (just point it to a folder, don't need to specify the file), lwsn will read all config file in that folder. then make sure all the path in your config are mapped to a network drive which all machine can find.
hope this help.