CG-Forum.com

Created by : Andrew Lee
Topic : Formula One in 2075

This is the first time I post my work here. I am still
an animation student in Bournemouth UK. This is my
current project which will be finished the end of this
month (August,2003). Modeling and rendering are done
by Softimage XSI 3.0. Welcome for any positive and
negative comments on my Formula One racer in 2075.

very nice work!!!
hi tech feeling.....let me driving!!

Hey very nice work here. I think the modeling and texturing are very good... but the design of the vehicle... should it be the other way around? You know, the tail being the head... simple areodynamic ma... The air resistance will make it slow and very unstable to race ma.

Thanks for you guys comments. I have just finished my final project, which was compeleted a short animation of that single wheel vehicle.

Actaully, I have considered about reverse the front and the back. But the final design is the wheel on the rear of the vehicle. It is because there is two jet engines located on the front of the vehicle. They used for balance the vehicle, lift up the front and also can turn the vehicle into a corner. Because of the single wheel design, the jet engines can also can turn the vehicle in 360 degree.

If you see my final animation. You will understand how does the vehicle works. But I don't know how to post my animation yet. Still try to figure it out.