Use CV Curve....

[Maya初仔]

If i use CV Curve to revolve it be be an orange! Afterward,i would like to select thier front Vertex!! But i don't want to select thier backside vertex at the same time !!! Are there any setting as polygons Backface culling??? Cos, every time i select front side vertex, i will also select backside one!!!
Many ths for helping!!

[3DMan]

我都唔知依家NURBS有冇得咁做, 不過以前我會將Camera的"FarClipPlane"調至較細數值 (例如少於4以下), 好讓距離Camera較遠的面不能display出來, 咁就唔會selcect到後面o既點。

[stantang]

Yes, the FarClipPlane function is still working. Or if you just want to work on the front part, you can select all the front vertex in the top panel, go to the panel you want to work on then go to the penal menubar --> Show --> Isloate view--> view selected. This method only works with Maya 3.5 or above.

[Maya初仔]

MANY THS! I WILL TRY IT !!!

[Maya初仔]

MANY THS! I WILL TRY IT !!!