當polygon轉做subdivision之後，又做左好多次full crease同partial crease,可唔可以再轉番做LOW polygon？

[nice_work]

當polygon轉做subdivision之後，又做左好多次full crease同partial crease,可唔可以再轉番做LOW polygon？

[stantang]

Don't understand totally of what you mean. If you want to get the original polyShape back from the converted subD, you can make a deplicate of the subD, then run a convert subD to poly and delete the tessShape.

[nice_work]

low polygon picture

[nice_work]

當轉左做subdivision,好似由圖一(low polygon)轉成圖二(subdivision)，有無可能轉番做low polygon(圖一)，問題系如果就咁convert to polygon，會變成high polygon

[nice_work]

delete the tessShape<---
唔系好明你個方法，有無圖可以demonstrate下,唔該~~~

[stantang]

delete the tessShape<---
唔系好明你個方法，有無圖可以demonstrate下,唔該~~~

ok, here you go

[nice_work]

呢個方法的確系可以轉番做lowpolygon，但系要再轉做subdiv時,佢依然記住之前做過gei full/partial crease

[stantang]

呢個方法的確系可以轉番做lowpolygon，但系要再轉做subdiv時,佢依然記住之前做過gei full/partial crease

Isn't that nice?

You said nothing about not wanting the history, so I assume you need it. If you don't want that, just use "vertices" for the tessellation method and level "0" when convert the subD to poly. Then instead of deleting the tessShape, delete the "HistPoly".

[nice_work]

problem

[nice_work]

呢個方法真系神奇，我見到未見過,但我第二次想再試，唔知點解又唔見左polyToSubshade1Histpolygon，所以仲未試"vertices" for the tessellation method

[nice_work]

啊，我明了,但仲未試"vertices" for the tessellation method

[nice_work]

"vertices" for the tessellation method，唔知你系咪咁gei意思。已經系level 0 ，但仍然有history

[stantang]

"vertices" for the tessellation method，唔知你系咪咁gei意思。已經系level 0 ，但仍然有history

the tessellation method is an option when you convert the subD to poly...

[nice_work]

唔該曬，你答得好detail，但系點解convert左之後,有d黑邊咁，正常定唔正常？又點轉番無黑邊呢？

[nice_work]

PICTURE